Telos Zephyr Xstream - Manual (Page 334)

USER’S MANUAL
Appendix 6 – Special Operational Modes 322
TRANSMITTING AN MPEG Layer 3 or AAC STREAM
Changing the Interface selection in the 3rd TEL menu to Ethernet will automatically start a
stream. The bit rate and Transmit (coding mode) for that stream are determined in the CODEC
menu (see above). The party(ies) connecting to this stream will need your IP address to connect
to it.
RECEIVING IN ETHERNET MODE – The DIAL Menu
Connecting to a Stream from another Xstream
1. Press <DIAL>
2. Enter the IP address of the desired stream (use the <*> or <#> key of the "."
character.
3. Press <DIAL> again
w
IMPORTANT TIP!
The system will automatically determine the coding mode and bit rate automatically.
h
HOT TIP!
IP addresses do not include leading Zeros If you are connecting to an IP address given to
you as 012.345.000.789 the correct IP address would be 12.345.0.789
In SIP mode this will establish a two‐way audio connection. In the case of RTP mode, "dialing" in
this manner allows you to receive from that site. If they wish to receive your audio, they would
need to “dial” you. Of course, they could receive from some other site simultaneously sending
to your site. Multiple sites may connect simultaneously.