Telos Zephyr Xstream User Manual
Page 282
USER’S MANUAL
Section 13: Deep Tech Information and Troubleshooting 270
DNS –
This is the IP address of the DNS (Domain Name Server) you will be using.
Press <SYSTEM> and enter:
FTP site ‐
This would normally be ftp.zephyr.com if downloading from Telos FTP site.
3. Update the unit. Select FTP update... and press <SEL>. Press <
5> or <6> to choose
OK . Press <SEL>.
The unit will reboot once the update is complete. It may also give a message about
"invalid non volatile RAM values". This message is normal.
4. Press <SYSTEM> once and verify that the new software version is shown. If not,
repeat the update. The update process is complete.
NOTE: It is not abnormal for the system to display a message "Some corrupt non
volatile values were detected". You can disregard this message.
h
HOT TIP!
If you need to "borrow" the IP address of a Windows computer to use when updating your
Xstream, here are some tips:
1. Go to the MS-DOS command line of the Windows machine (Run " cmd
XP, 2000 or Win NT; or Run "command
2. From the command line type "ipconfig
for that machine will be displayed. Write down this information.
3. Power off the computer that you just obtained this information from (or disconnect it
from your network)
4. Enter this IP address and gateway into the Xstream
5. Connect the Xstream to your network.
6. Be sure to delete these entries from the Xstream when you are finished. You can then
power up the computer (or reconnect it to the network).