TROY Group MAN-EXT2000 User Manual

Page 97

Novell Network Configuration 5-25

Push ESCAPE and save the changes.

Push ESCAPE and select Queues Serviced by
Printer.

g. Highlight the printer name that you just configured

and press ENTER.

h. Press INSERT, choose the desired print queue, and

press ENTER (you can accept the default priority).

Press ESCAPE several times to exit PCONSOLE.

Insert the TROY XCD Print Server Software diskette or
CD-ROM into your PC and run the XCONFIG utility
(in the

\utilities

directory on the CD-ROM)

Select the TROY XCD print server from the list of
print servers. When you get the message that the print
server is connected, press the ENTER key and type the
password ACCESS in response to the "#" prompt (the
password will not echo), and then press the ENTER key
again in response to the

Enter Username>

prompt. When you get the

Local>

prompt, type:

SET NET NPRINTER

nlm number ON service

SET NET RESCAN

EXIT

where nlm is the name of the PSERVER NLM on your
file server, number is the printer number (must match
the printer number you selected during the PCONSOLE
configuration in the previous steps) and service is the
name of the service (the default service names are listed
in the Default Print Server Names section of this chapter).