TROY Group MAN-EXT2000 - Manual (Page 41)

Management Methods 3-5
you are connected, enter the password ( ACCESS is the
default password) and select the protocol or other item that
you wish to configure. You will then be connected to the
appropriate web page for configuration of that item. You
may use the normal browser buttons to move forward and
back through the web pages.
TROY XCD Print Server Console
All TROY XCD print servers support a sophisticated
command-line oriented console for configuration and
management. This console contains features that are not
available through XAdmin or WebXAdmin, including
sophisticated diagnostic capabilities. The TROY XCD print
server console can be accessed via TELNET, DEC NCP/
NCL/ccr, the print server serial port (if present), and the
TROY XCD XCONFIG NetWare utility. It also available
through one of the web pages using the WebXAdmin facility.
The general configuration procedure is the same regardless
of which method is used.
DEC NCP, NCL, ccr. To connect to the print server
console with the VMS NCP utility, use the following
commands:
MCR NCP
CONNECT VIA circuit PHY ADD ethernetaddress
where circuit is the circuit-ID of the VAX or Alpha (for
example, SVA-0 for most DEC workstations, MNA-0 for
XMI systems, BNA-0 for BI systems, and QNA-0 for Q-BUS
systems) and ethernetaddress is the hardware address of the
print server (for example, 00-40-17-00-61-35).