TROY Group MAN-EXT2000 - Manual (Page 140)

11-4 LAT Network Configuration
$MCR LATCP
CREATE PORT LTA33:/APPLICATION
SET PORT LTA33:/NODE=XCD_003C51/PORT=P1
SHOW PORT LTA33:
EXIT
$SET TERM LTA33:/PASTHRU/TAB/NOBROADCAST-
/PERM
$SET DEVICE/SPOOL LTA33:
$INIT/QUEUE/START/ON=LTA33:/PROC=LATSYM XCD
Substitute your actual node name, port name (P1, S1,
P2, S2, or LN), LAT port and queue name for the ones
in the example. If you are using a service name,
specify
/SERVICE= servicenam e instead of /PORT=P1 .
Important: Use the default names unless you have
specifically changed the names via the TROY XCD
print server remote console.
Important: Be sure to specify PROC=LATSYM or the
queue will not service requests from multiple host
computers.
3. Execute the command file you have just created by
typing "@" plus the file name in response to the VMS
"$" prompt (for example,
@LATSTART.COM ). For
additional convenience, you may want to include the
"
@filename " command in your system startup file so
that the procedure is executed automatically when the
system is booted.
4. Define or modify a form for use with the TROY XCD
print server. VMS uses forms to define the page
layout. If you are printing graphics or PostScript jobs,
you must define your form for
NOTRUNCATE and