TROY Group MAN-EXT2000 - Manual (Page 49)

TCP/IP Network Configuration 4-3
you must use a different name). In any case, the
node name in the /etc/hosts file must match the
node name in the /etc/printcap file.
Note: Some systems, such as HP/UX and AIX allow
you to enter the IP address as the host name when
setting up the print queue. If this is the case, you do
not need to configure the hosts file.
2. Choose which TROY XCD print server service you
want to use. There are two types of services available
on the TROY XCD print server. Binary services pass
data through unmodified and are therefore required for
PCL or PostScript rasterized graphics printouts. Text
services add a carriage return at the end of each line for
proper formatting of UNIX text files (which end in
linefeed and do not have carriage returns). The text
service can also be used for non-rasterized graphics,
such as ASCII PostScript graphics or many types of
PCL graphics.
If you are using the first parallel port on the print
server, choose one of the available services (this
service name will be used in step 3):
BINARY_P1 Binary (parallel port)
TEXT_P1 Text (parallel port)
The XConnect II and Pony 100 also support the
following services:
BINARY_S1 Binary (serial port)
TEXT_S1 Text (serial port)
The XConnect 100 supports the following additional
services: