TROY Group MAN-EXT2000 - Manual (Page 204)

A-2 Command Summary
print server (for example, 00-40-17-00-61-35). Type the
command
SHOW KNOW CIRCUITS at the NCP> prompt if you
do not know the circuit ID.
Newer OpenVMS systems use NCL instead of NCP. The
NCL command to connect to the print server console is:
SET HOST/MOP/CIRCUIT= circuit/ADD=ethernetaddress
ULTRIX systems use the addnode and ccr commands as
follows:
addnode xcdname -c circuit -h ethernetaddress
ccr xcdname
where xcdname is an arbitrary name for the print server
(each print server on the network needs a unique name).
In all cases, you will get a message like Console
Connected or Remote Console Reserved when you are
connected. When you are connected, push RETURN or
ENTER to get the "
# " prompt, enter the password ACCESS (it
will not print), and type anything in response to the Enter
Username> prompt. When you get the Local> prompt, you
are ready to enter commands.
Note: The commands available are generally a subset of the
ones used on the DECserver terminal server. Note that
unlike the DECserver, there is no distinction between the
SET and DEFINE commands or between the CLEAR and
PURGE commands. Instead, when you type CTRL-D to exit
the remote console, any of these commands take effect
immediately and the results are stored permanently (for
example, it is not necessary to enter both a SET and a
DEFINE to execute a command and save the results).