TROY Group MAN-EXT2000 - Manual (Page 28)

2-14 Installation
H1000
Thin
Ethernet
Cable
Thin
Ethernet
Cable
"T"
50 ohm
Terminator
A
B
Thin
Ethernet
Cable
"T"
Figure 2-5
Connecting the Print Server to a 10base2 thin Ethernet network
Connecting the XConnect II or XConnect II Lite-2
to a Thin Ethernet Network
To connect an XConnect II or XConnect II Lite-2 to a thin
Ethernet network, first check to see that switches 2 and 3
(10baseT/10base2) are in the ON position.
If you are installing the print server onto an existing network,
the "T" connector may already be installed on the cable. If
this is the case, simply connect the "T" connector to the BNC
connector on the print server's BNC connector as shown in
figure 2-5A (if the connection is in the middle of the thin
Ethernet segment) or 2-5B (if the connection is at the end of
the thin Ethernet segment). This operation can be performed
without impacting the operation of the network.
If the "T" connector is not already installed, proceed as
follows (caution: if you are connecting to a live network,