TROY Group MAN-EXT2000 - Manual (Page 231)

Reloading the Firmware C-7
Power the printer off and then on again, enter the SET LOAD
ENABLE command, and then type EXIT to exit the remote
console and retry the download.
Downloading from a NetWare Server
To download from a NetWare server, first copy the file
XJET.BIN into the \login directory on your SYS
partition ( SYS:\LOGIN ). Using the \login directory
will eliminate any potential file protection problems.
Connect to the print server remote console using
XCONFIG or the serial port (refer to Appendix A if you do
not know how to do this) and enter the following
commands in response to
Local> prompt.
SET LOAD HOST fileservername
SET LOAD SOFTWARE SYS:\LOGIN\XJET.BIN
SET LOAD ENABLE
where fileservername is the name of the file server. When
you type a CTRL-D to exit the remote console, the file
XJET.BIN will then be loaded into the print server. The
red diagnostic LED will blink during the load process and
will go out when the process is complete.
If the red LED does not go out after about two minutes,
check to make sure that you correctly entered all
parameters and that your network connections are good.
Then power the print server off and then on again, enter the
SET LOAD ENABLE command, and exit the remote console
to retry the download.