TROY Group MAN-EXT2000 - Manual (Page 109)

Windows NT/LAN Server Configuration 7-3
Double click on the TCP/IP Protocol option and add the
host IP address, subnet mask, and gateway address.
Consult your system manager for these addresses. If you
are not directly connected to the Internet, you may assign
any arbitrary Class C address of the form
aaa.bbb.ccc.ddd, where aaa is any number from 192 to
222, bbb and ccc are any number from 0 to 255, and ddd
is any number from 0 to 254; for example, 192.189.207.3.
You may also use a subnet mask of 255.255.255.0 with
no gateway address. If you have more than one LAN
adapter card, select the one you want to use for TCP/IP.
If you have more than one LAN adapter card, select the
one you want to use with TCP/IP. Click OK twice to
exit (you may need to restart the system).
2. If you have not already configured the print server IP
address, you will need to do so now. The simplest way
to do this with Windows NT 4.x is to use XAdmin-32
as described in Chapter 3.
As an alternative, or if you have Windows NT 3.5x, you
may go to the MS-DOS Command Prompt and use the
arp -s command to enter the IP address into the TROY
XCD print server as shown in the following example:
arp -s 192.189.207.77 00-40-17-00-ed-d6
ping 192.189.207.77
Again, substitute your actual IP address for
192.189.207.77 , and replace the 00-40-17-00-ed-d6
with the actual Ethernet hardware address of the TROY
XCD print server (which can be found on the label
affixed to the bottom of the box or via the printer self-