TROY Group MAN-EXT2000 - Manual (Page 110)

7-4 Windows NT/LAN Server Configuration
test). If you get the message "The arp entry addition
failed: 3", try pinging a known device on the network
using the command
ping ipaddress , where ipaddress
is the IP address of that device.
Important: You must be on the same Ethernet
segment (that is, there cannot be a router between the
TROY XCD print server and the Windows NT system)
to use the
arp -s command. If there is a router, you
may use BOOTP or other methods described in
Chapter 4 to enter the IP address. Also, this method
only works the first time the TROY XCD print server is
configured. If the TROY XCD print server already has
an IP address, you may use TELNET to access it and
change the IP address using the
SET IP ADDRESS
command described in Appendix A.
Important: The TROY XCD print server has a default
IP address of 192.0.0.192 (192.189.207.254 on older
firmware versions). You must change this address to a
unique value to avoid having duplicate IP addresses.
Windows NT V4.xx Configuration
Note: If you have Windows NT V3.5 or V3.51, skip to the
next section.
1. Go to the Start button, choose Settings, and then
select Printer. Double click on the Add Printer icon
to get the Add Printer Wizard. Click. Select My
Computer (Not Network Printer) and click on Next.
2. Select Add Port, select LPR Port from the list of
available ports, and click on New Port.