TROY Group MAN-EXT2000 - Manual (Page 31)

Installation 2-17
The TROY XCD print server will go through the following
startup sequence:
1. It will run through a set of power-up diagnostics for a
few seconds. If the print server is operating properly, the
TEST LED will blink momentarily and then go out. If
the TEST LED blinks continuously in a regular pattern,
there is a problem. If this is the case, first verify that you
have a good Ethernet connection and then try powering the
unit off and then on again. If the problem persists, refer to
the Troubleshooting chapter in this manual.
2. When the test LED goes out, the other LEDs on the print
server will come on as follows:
• On the XConnect II and XConnect II Lite, the LINK
LED will blink to show activity on the network. The
XMIT and RCV LEDs will come on solid if there is a
valid 10baseT connection (they are not used with
10base2).
• On the XConnect 100, the Link OK LED will blink if
the print server detects activity on the network. The
100baseTX LED will come on if a valid 100baseTX
connection is detected (this LED will not come on if
10baseT is used).
• On the Pony 100, the Link LED will come on solid if
there is a valid 10baseT or 100baseTX connection.
• On the Pony Print Server Plus, the LED will blink
randomly.
If the LEDs do not come on as described, there may be a
cabling problem or a bad hub port; if this is the case, try a
different cable and/or hub port.