beautypg.com

4 installation, Switch 4 (console/serial printer) – TROY Group MAN-EXT2000 User Manual

Page 18

background image

2-4 Installation

position will conserve energy by drawing less power from the
printer.

Note:

With V3.22 or earlier firmware (included with

XConnect II and XConnect II Lite print servers shipped from
TROY XCD prior to September, 1995), switches 2 and 3
must both be in the OFF position for 10baseT operation or in
the ON position for 10base2 operation.

Switch 4 (Console/Serial Printer)

This switch defines whether the serial port will be used for a
console terminal or a serial printer. Leave switch 4 in the
default OFF position if you want to use the serial port for a
console terminal.

Figure 2-2

XConnect 100 Switch and LEDs

Link OK LED

Test LED

100baseTX LED

Power Connector

Parallel Port 2

Test Switch

Console/
Serial Port 2

Serial Port 1

Parallel Port 1

100baseTX/
10baseT
Connector

Serial ports are 9-pin male D-connectors

XConnect 100 Front View

XConnect 100 Rear View