TROY Group MAN-EXT2000 - Manual (Page 91)

Novell Network Configuration 5-19
Novell's NWAdmin or PCONSOLE to add the print queue to
the NetWare server. Then you must configure the print
server for remote printer operation using XAdmin32,
XAdmin, JetAdmin, WebXAdmin, or the print server
console.
Important Note: You cannot configure both Queue Server
and Remote Printer mode on the same print server port. It is
possible, however, to configure a multiport print server (such
as the XConnect 100) with one port running in Queue Server
mode and the other in Remote Printer mode.
Configuring the Print Server and Print Queue using
NWADMIN and XAdmin32, XAdmin, WebXAdmin, or
JetAdmin (NDS Remote Printer Mode):
To configure an TROY XCD print server for remote printer
mode with NWADMIN (NetWare Administrator utility) and
XAdmin32, XAdmin, WebXAdmin, or JetAdmin, first make
sure that you have V3.28 or later firmware (refer to the self-
test page or do a SHOW VERSION command from the
console). Then perform the following steps:
1. Make sure that the PSERVER NLM (NetWare
Loadable Module) is loaded on your file server and that
you are logged in as ADMIN in NDS mode on the
NetWare 4.xx file server.
2. Start NWADMIN by double clicking on the icon.
Select the desired Container Object (Organizational
Unit) that will contain the new printer.
3. Select Object from the menu bar and then Create.
When you get the New Object menu, select Printer
and then OK.