TROY Group MAN-EXT2000 - Manual (Page 203)

Command Summary A-1
Appendix A
Command Summary
General Commands
Although it is not normally necessary to change the print server
default parameters, you can change the configuration through
any following methods:
• DEC NCP or NCL Utility
• TELNET
• TROY XCD XCONFIG NetWare Utility
• Serial Port
The general configuration procedure is the same regardless of
which method is used.
Certain print server NetWare parameters (such as the
NetWare service name) can also be changed by using the
Hewlett-Packard JetAdmin utility or TROY XCD XAdmin
utility.
DEC NCP, NCL, ccr. To connect to the print server
console with the VMS NCP utility, use the following
commands:
MCR NCP
CONNECT VIA circuit PHY ADD ethernetaddress
where circuit is the circuit-ID of the VAX or Alpha (for
example, SVA-0 for most DEC workstations, MNA-0 for
XMI systems, BNA-0 for BI systems, and QNA-0 for Q-BUS
systems) and ethernetaddress is the hardware address of the