TROY Group MAN-EXT2000 - Manual (Page 228)

C-4 Reloading the Firmware
where ipaddr is the IP address of the TROY XCD print
server, file is the name of the load file, and password is the
print server password (
ACCESS is the default password).
To download the file from most UNIX systems, enter the
following commands from the UNIX system prompt:
tftp ipaddress
tftp> binary
tftp> put file password
where ipaddress is the IP address of the TROY XCD print
server, file is the name of the load file, and password is the
print server password (
ACCESS is the default password).
Downloading from a UNIX Host
Computer using Slave Mode tftp
To download the print server firmware from a UNIX host
using slave mode tftp, first copy the file
XJET.BIN to that
host. Make sure that tftp is started by checking the
appropriate files on your system (generally speaking, tftp
must be enabled in your
/etc/services file and
possibly in another configuration file, such as /etc/
inetd.conf ). Refer to your UNIX system
documentation or man pages for additional information.
Now log into the print server remote console using
TELNET or the serial port (see Appendix A if you do not
know how to do this), and execute the following commands:
SET LOAD IP unixhost-ipaddress
SET LOAD SOFTWARE "pathname"
SET LOAD ENABLE