RAD Data comm HCD-E1 - Manual (Page 132)

Chapter 4 - Control from the Supervisory Port HCD-E1 Installation & Operation Manual
4-48 HCD-E1 Command Set Description 11/01/00 19:23
Syntax
F
Use
1. To display the current codes, type:
F
The terminal function entry screen is displayed. The screen includes
three separate lines, displayed one after the other. A typical screen,
showing all the three lines, is shown below:
CLEAR SCREEN = hhhhhhhh
CURSOR HOME = hhhhhhhh
CURSOR RIGHT = hhhhhhhh
where h indicates hexadecimal digits.
2. To change a code, bring the cursor under the first digit of the code to
be changed, by pressing , then enter the appropriate
hexadecimal digits of the code.
3. Repeat the procedure until all the necessary codes are changed.
HCD-E1 performs the command and displays the date and the time
followed by the HCD-E1 prompt.
H or HELP Purpose
Display an index of the control port commands and the options available for
each command.
Syntax
H or HELP
Use
Type:
H or HELP
HCD-E1 displays the first HELP page. Press any key to see the next page.
Note If H-RPT is connected on the HDSL link, you will also get commands for its
support.
When finished, HCD-E1 displays the date and the time followed by the
HCD-E1 prompt.