RAD Data comm ASMi-52 User Manual
Asmi-52
Table of contents
Document Outline
- Front Matter
- Quick Start Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Setup
- Chapter 3 Operation
- Chapter 4 Configuration
- Configuring ASMi-52 for Management
- Configuring ASMi-52 System Parameters
- Configuring the Physical Ports
- Configuring the SHDSL Interface
- Configuring the Power Backoff
- Configuring the Snext Margin
- Configuring the Current Margin
- Configuring the Power Spectral Density
- Configuring Line Probing
- Setting the Loop Attenuation Threshold
- Setting the SNR Margin Threshold
- Configuring the SHDSL Repeater
- Configuring the DTE Interface Data Rate
- Configuring the Data Rate in a Multiplexer Unit
- Configuring the E1 Interface
- Matching Remote Unit Settings With Local Unit Settings
- Configuring the T1 Interface
- Configuring the SHDSL Interface
- Additional Tasks
- Chapter 5 Configuring a Typical Application
- Chapter 6 Troubleshooting and Diagnostics
- Appendix A Interface Connector Specifications
- Appendix B IR-IP Interface Module
- Introduction
- Technical Specifications
- Physical Description
- IR-IP Management Subsystem
- Performing Preliminary Configuration
- IR-IP Management Utility
- Quick Setup Guide
- Defining Management Access
- Advanced Setup
- Using the Device Control Menu
- Viewing IR-IP configuration Data
- Using Diagnostic Tools (Ping Terminal)
- Erasing User’s Configuration
- Erasing IR-IP Software
- IR-IP Troubleshooting
- Appendix C Easy Config Device
- Index
- Drilling Template
- Back Matter