RAD Data comm HCD-E1 - Manual (Page 125)

HCD-E1 Installation & Operation Manual Chapter 4 - Control from the Supervisory Port
11/01/00 19:23 HCD-E1 Command Set Description 4-41
Use
•
To display the status information for a selected channel, type:
DSP ST CH 1
or DSP ST CH 2
A typical channel status display is shown below:
STATUS OF CH -1
INTERFACE = RS530
LOOPS
TYPE = REMOTE REM
REM LOCAL BERT T_
INBAND R_
INBAND
NO NO NO NO NO NO
PORT STATE = CONNECTED
RTS STATE = OFF
Display Format
The fields included in the status information display are listed below:
LOCAL Indicates the state of the local loopback:
•
NO - local loopback is deactivated.
•
YES - local loopback is activated.
REMOTE Indicates the state of the remote loopback:
•
NO - remote loopback is deactivated.
•
YES - remote loopback is activated.
REM REM Indicates the state of the remote remote loopback:
•
NO - remote remote loopback is deactivated.
•
YES - remote remote loopback is activated.
BERT Indicates the state of the BER test:
•
NO - BER test is deactivated.
•
YES - BER test is activated.
T_INBAND Displays YES to indicate that the user requested the
sending of the in-band remote loopback activation
sequence.
R_INBAND Displays YES when a loopback has been connected as a
result of the reception of the in-band remote loopback
activation sequence.
PORT STATE Displays whether the selected channel is connected to
another port:
•
CONNECTED - the channel is connected.
•
NOT CONNECTED - the channel is not connected.
RTS Displays the state of the RTS line in the channel
connector:
•
OFF - the RTS line is not active.
•
ON - the RTS line is active.