RAD Data comm HCD-E1 - Manual (Page 101)

HCD-E1 Installation & Operation Manual Chapter 4 - Control from the Supervisory Port
11/01/00 19:23 HCD-E1 Command Set Description 4-17
A typical display, as seen after all the parameters are selected, is shown
below:
DAY = 01
MONTH = 03
YEAR [4 CHARS] = 1996
WEEK DAY =FRI
Below HCD-E1 displays the date and time (note that the date has changed),
followed by the HCD-E1 prompt.
DEF AGENT Purpose
Display and modify the current SNMP agent parameters. Refer to
Appendix A for additional explanations.
To enable SNMP and Telnet management, it is necessary to define all the
parameters.
Syntax
DEF AGENT
Use
1. To define the SNMP agent parameters, type:
DEF AGENT
You will see the entry line for the first parameter,
TELNET_APATHY_TIME
10 MIN
2. If you do not want to change the current value of the parameter, press
to confirm it and continue to the next line, otherwise type in the
new value and then press . HCD-E1 displays the entry line for
the next parameter.
3. Repeat the procedure until all the parameters are defined, and then
press to end.
A typical display, as seen after all the parameters are selected, is shown
below:
IP ADDRESS IS: = 192.114.029.233
READ COMMUNITY IS: = public
WRITE COMMUNITY IS: = private
TRAP COMMUNITY IS: = public
After performing the command, HCD-E1 displays the date and time,
followed by the HCD-E1 prompt.