Paradyne 4200 - Manual (Page 91)

3. ADSL Facility Commands
4200-A2-GB20-00 August 2002 3-55
Example
Retrieve profile 6.
RTRV-PROFILE-ADSLUPALM:TAMPA:6:42;
TAMPA 02-07-24 12:30:43
M 42 COMPLD
/* RTRV-PROFILE-ADSLUPALM:TAMPA:6 */
6:LOCAL:TAMPA101:LOFS-L=0,LOSS=0,LOLS=0,ES-L=120,SES-L=15,
UAS-L=0,INCRATE-F=0,DECRATE-F=0,INIT=N
;
Related Command
ED-PROFILE-ADSLUPALM on page 3-21
ENT-PROFILE-ADSLALM on page 3-26
[adslprof_nblk]
(continued)
DECRATE-F: Decreasing Rate (fast channel). SNMP rate change trap
and TL1 autonomous message are sent if the current rate is
≤
the
previous rate minus this threshold (0-2176 kbps in 32 kbps increments,
where 0 disables the messages). The default is 0.
INITFAIL: Initialization Failure. Enables or disables InitFailureTrap
messages specified in RFC 2662.
– Y: Enable Initialization Failure Trap messages only.
– N: Disable Initialization Failure Trap messages only (Default).
If not specified, the values of these parameters remain unchanged.
errcde Error code (see Appendix A, Error Codes )
Table 3-42. RTRV-PROFILE-ADSLUPALM Response Parameters (2 of 2)
Parameter Explanation