Paradyne 4200 - Manual (Page 114)

5. ATM Commands
5-4 August 2002 4200-A2-GB20-00
DLT-VCL
The DLT-VCL command deletes selected ATM interface Virtual Channel Links
(VCL) that are not in use.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* DLT-VCL:[tid]:aid_vcl:[ctag][:] */
;
Table 5-3. DLT-VCL Command Parameters
DLT-VCL:[tid]:aid_vcl:[ctag][:];
RESTRICTIONS: All parameters in this command are position-defined. If the VCL is
cross-connected, the deletion fails.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_vcl Virtual Circuit Identifier for the Virtual Circuit. The value can be
preceded with AID=, but this is not required. Grouping and ranging are
allowed. Enter any of in the following formats, replacing lower-case
parameters with the values given:
NTVCL-vpi-vci: VCL in the NT
LTVCL-rack-shelf-slot-circuit-vpi-vci: VCL in an LT circuit
– rack: Rack number (1)
– shelf: Shelf number (1)
– slot: LT slot number (1)
– circuit: DSL circuit on the LT (1
−
4)
– vpi: Virtual Path Identifier (for LT vpi=0, for NT vpi=0
−
15)
– vci Virtual Channel Identifier (for LT vpi=32
−
63,
for NT vpi=32
−
1023)
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.