Paradyne time mib (pdn_time.mib), Paradyne mpe_atmconf.mib, C-44 – Paradyne 4200 User Manual
Page 368
C. Traps and MIBs
C-44
August 2002
4200-A2-GB20-00
Paradyne Time MIB (pdn_Time.mib)
The Paradyne Time MIB (pdn_Time.mib) controls the date and time on the unit.
Paradyne mpe_ATMConf.mib
This MIB is used for configuration of ATM-specific objects that are not available
through the standard MIB RFC 2515.
Table C-23. Paradyne Time MIB Objects
Object
Description
Setting/Contents
devDateAndTime
Displays the unit’s date and time and
allows the NMS to change them to the
appropriate time zone.
Read/write.
devNTPServerIP
Allows an NMS to configure the NTP
server and IP address.
Read/write.
devNTPMode
Allows an NMS to configure the NTP
mode.
Read/write. Valid Values are:
T
Unicast: NTP polls a specific server. The
NTP server must have been configured
using the NTPServerIP object.
T
Broadcast: NTP broadcasts a request and
any NTP server can respond.
Table C-24. Paradyne mpe_ATMConf.mib
Object
Description
Setting/Contents
mpeAtmLoopbackLocationCode
Identifies this module for the purpose of
OAM f5 loopback.
Read/write.
entPhysicalIndex
The physical index of the card in the
DSLAM.
Not accessible.