Paradyne 4200 - Manual (Page 126)

5. ATM Commands
5-16 August 2002 4200-A2-GB20-00
RTRV-PROFILE-ATMACC
The RTRV-PROFILE-ATMACC command retrieves configuration parameters of an
ATM access profile.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/*
RTRV-PROFILE-ATMCC:[tid]:atmacc_profile_id:[ctag][::,profile
_scope] */
atm_profile_id:profile_scope;profile_name:atmacc_nblk
;
Error Response:
sid yy-mm-dd hh:mm:ss
M c DENY
/*
RTRV-PROFILE-ATMACC:[tid]:atmacc_profile_id:[ctag][::,profil
e_scope] */
errcde
;
Table 5-13. RTRV-PROFILE-ATMACC Command Parameters
RTRV-PROFILE-ATMACC:[tid]:atmacc_profile_id:[ctag]::,
[profile_scope];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
atmacc_profile_id Numeric Identifier for an ATM profile. The profile must not already be
in use. Grouping is allowed and ALL may be used. Valid values are:
1: Default profile for LT line
2: Default profile for NT line
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
[profile_scope] Scope of the profile. The valid value is LOCAL (local to this stack
only). If no value is specified, this parameter is ignored (all values are
specified).