Paradyne 4200 - Manual (Page 118)

5. ATM Commands
5-8 August 2002 4200-A2-GB20-00
ENT-PROFILE-TRAFDSC
The ENT-PROFILE-TRAFDSC command creates a new ATM Traffic Descriptor
profile.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/*
ENT-PROFILE-TRAFDSC:[tid]:trafdsc:[ctag]::trafdscnm,,trafdsc
_type:[trafdsc_nblk]; */
;
Table 5-7. ENT-PROFILE-TRAFDSC Command Parameters
ENT-PROFILE-TRAFDSC:[tid]:trafdsc_profile_id:[ctag]::profil
e_name,,trafdsc_type:[trafdsc_nblk];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
trafdsc_profile_id Numeric identifier of a profile (1
−
250). Grouping and ranging are
allowed.
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
profile_name Name (32 characters maximum) that uniquely identifies profile. The
value cannot contain any characters other than letters, numbers,
hyphens (-), and underscores (_).
trafdsc_type Traffic descriptor type. The valid value is UBR (UBR best effort).
trafdsc_nblk Named parameter block for the ATM traffic descriptor profile. The valid
value is:
DISCARD: Partial packet discard
– Yes: Partial packet discard is enabled
– No: Partial packet discard is disabled (default)