Paradyne 4200 - Manual (Page 337)

C. Traps and MIBs
4200-A2-GB20-00 August 2002 C-13
MIB II (RFC 2863) Interface Test Table
For GranDSLAM 4200, the Interface Test Table is supported for interface-related
diagnostic tests such as loopback.
MIB II (RFC 2863) ifTestEntry Table
This table contains one entry per interface and defines objects that allow a
network manager to instruct an agent to test an interface. For the
GranDSLAM 4200, loopback tests can be performed. The objects supported are
the following:
T ifTestId
T IfTestStatus
T ifTestType
T ifTestResult
T ifTestCode
T ifTestOwner
T ifIndex
ATM MIB (AtoM) (RFC 2515)
The ATM MIB provides objects for management of the ATM cell and AAL5
interfaces, as well as guidance for the ifTable. Nine groups are supported:
T ATM Interface Configuration Parameter Group (atmInterfaceConfEntry)
−
Supported. See ATM Interface Configuration Parameter Group (RFC 2515) on
page C-14 .
T TC Sublayer Group
−
Not supported.
T ATM Traffic Descriptor Group
−
Contains a set of ATM traffic parameters
including the ATM traffic service category. See ATM Interface Traffic Descriptor
Group (RFC 2515) on page C-15.
T ATM Virtual Channel Link (VCL) Configuration Group
−
Supported. See ATM
VCL Configuration Group (RFC 2515) on page C-16.
T Virtual Channel Cross Connect Group
−
Supported. See Virtual Channel
Cross Connect Group (RFC 2515) on page C-17.