Paradyne 4200 User Manual
Page 173
8. IP Access Commands
4200-A2-GB20-00
August 2002
8-15
Table 8-12. REPT-OPSTAT-IPPORT Response Parameters
Parameter Explanation
tid Target
NE
identification
yy-mm-dd
Year, month, and day
hh:mm:ss
Hour, minute, and second
M
Message generated in response to an input command
c
If provided, ctag; otherwise 0
COMPLD Completed
DENY
Input command is denied
/* */
Enclosed are human readable comments – unspecified format
errcde Error
code
aid_ipport
Access identifier of the IP port to be entered. The value can be
preceded with AID=, but this is not required. The valid values are:
ATM-1: First IP-over-ATM interface in the NT
ATM-2: Second IP-over-ATM interface in the NT
ETH-1: First Ethernet interface in the NT
Grouping and ranging are allowed.
[op_ipport]
IP port operational parameters. Valid values are:
CURRATE: Displays the auto-sensed rate of operation of the Ethernet
port or the current bandwidth associated with the ATM VCs in bps. The
following rates are supported:
– 0: The current bandwidth associated with the ATM VCs for the
entry is 0 or the Ethernet port is disconnected or disabled. The
bandwidth associated with UBR connections is 0 bps.
– 10000000: The current auto-sensed rate on the Ethernet port is
10 Mbps.
– 100000000: The current auto-sensed rate on the Ethernet port is
100 Mbps.
CURDX: Displays the current line duplex mode. The following values
are supported:
– 2DX: The current auto-sensed mode is half-duplex (2-wire)
operation (ETH-1 only).
– 4DX: The current auto-sensed mode is full duplex (4-wire)
operation (ETH-1, ATM-1, ATM-2).
– NONE: The line is disconnected (ETH-1 only).
value
The value of the parameter as specified by op_ipport.