Ed-profile-adsldnalm – Paradyne 4200 User Manual
Page 52
3. ADSL Facility Commands
3-16
August 2002
4200-A2-GB20-00
ED-PROFILE-ADSLDNALM
The ED-PROFILE-ADSLDNALM command enables you to edit ADSL alarm line
configuration parameters for the downstream direction (from ATU-C to ATU-R) in
an ADSL Alarm Profile. See
information on how to create a new ADSL alarm profile.
Table 3-13. ED-PROFILE-ADSLDNALM Command Parameters
ED-PROFILE-ADSLDNALM:[tid]:adsl_profile_id:[ctag]:::[adslpr
of_nblk];
RESTRICTIONS: All parameters in this command are position-defined. After a profile is
activated, its parameters cannot be edited.
[tid]
Identification of the target NE. TID is optional and has a default value of
null. The NE's SID code is the only other valid value.
adsl_profile_id
Numeric identifier of a profile (1
−
30).
[ctag]
Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
[adslprof_nblk]
ADSL parameter block containing one or more of the following named
parameters (separated by commas):
LOFS-L: Loss Of Frame Seconds (line). SNMP trap and TL1
autonomous message are sent if the number of LOFS events in a
15-minute interval meets or exceeds the selected value (0
−
900
seconds, where 0 disables the messages). The default is 0.
LPRS-L: Loss Of Power Seconds (line). SNMP trap and TL1
autonomous messages are sent if the number of LPRS events in a
15-minute interval meets or exceeds the selected value (0
−
900
seconds, where 0 disables the messages). The default is 0. (This
statistic is not incremented when a Hotwire Model 6390 ReachDSL
Modem is attached to the line.)
ES-L: Errored Seconds (line). SNMP trap and TL1 autonomous
message are sent if the number of ES events in a 15-minute interval
meets or exceeds the selected value (0
−
900 seconds, where 0 disables
the messages). The default is 0.
SES-L: Severely Errored Seconds (line). SNMP trap and TL1
autonomous message are sent if the number of SES events in a
15-minute interval meets or exceeds the selected value (0
−
900
seconds, where 0 disables the messages). The default is 0.
UAS-L: Unavailable Seconds (line). SNMP trap and TL1 autonomous
message are sent if the number of UAS events in a 15-minute interval
meets or exceeds the selected value (0
−
900 seconds, where 0 disables
the messages). The default is 0.
INCRATE-F: Increasing Rate (fast channel). SNMP rate change trap
and TL1 autonomous message are sent if the current rate is
≥
the
previous rate plus this threshold (0-2176 kbps in 32 kbps increments,
where 0 disables the messages). The default is 0.
DECRATE-F: Decreasing Rate (fast channel). SNMP rate change trap
and TL1 autonomous message are sent if the current rate is
≤
the
previous rate minus this threshold (0-2176 kbps in 32 kbps increments,
where 0 disables the messages). The default is 0.
If not specified, the values of these parameters remain unchanged.