Paradyne 4200 - Manual (Page 271)

14. System Commands
4200-A2-GB20-00 August 2002 14-9
INH-MSG-ALL
The INH-MSG-ALL command inhibits the reporting of all autonomous messages
at or below a specified severity level. This command affects only the issuing user’s
session and has no effect on other indicators or on NE operation. The NE
continues to respond fully to RTRV-ALM and RTRV-COND commands.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response will be sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* INH-MSG-ALL:[tid]:[aidall]:[ctag]::[ntfcncde] */
;
Error Response:
sid yy-mm-dd hh:mm:ss
M c DENY
/* INH-MSG-ALL:[tid]:[aidall]:[ctag]::[ntfcncde] */
errcde
;
Table 14-8. INH-MSG-ALL Command Format
INH-MSG-ALL:[tid]:[aid_all]:[ctag]::[ntfcnde];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] The identification of the target NE. TID is optional and has a default
value of null. The NE's SID code is the only other valid value.
[aid_all] Access Identifier for all entities. The value is ALL.
[ctag] The correlation tag (6 characters maximum) that links an input
command with associated output responses. It is optional with a default
of 0.
[ntfcncde] Notification code for some autonomous messages. Grouping is allowed.
Valid values are:
CR = Critical alarm
MJ = Major alarm
MN = Minor alarm
NA = Not alarmed