Paradyne 4200 - Manual (Page 208)

10. Fault Commands
10-16 August 2002 4200-A2-GB20-00
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response will be sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* RTRV-ATTR-ADSL:[tid]:aidall_adsl:[ctag]::[ntfncde],
[cond_adsl],[locn],[dirn] */
"aidall_adsl,aid_type:ntfncde,cond_adsl,[locn],[dirn]"
;
Error Response:
sid yy-mm-dd hh:mm:ss
M c DENY
/* RTRV-ATTR-ADSL:[tid]:aidall_adsl:[ctag]::[ntfncde],
[cond_adsl],[locn],[dirn] */
errcde
;
[cond_adsl]
(continued)
INCRATE-F: Increasing rate (fast channel) (near end, far end, not
alarmed). There is no corresponding standing condition clear message
for this message.
DECRATE-F: Decreasing rate (fast channel) (near end, far end, not
alarmed). There is no corresponding standing condition clear message
for this message.
LPRS-L: Loss of Power Seconds (line) (far end only) (not alarmed)
LOSS-L: Loss of Signal Seconds (line) (near end only) (not alarmed)
[locn] Location of the condition. Valid values are:
NEND: Near End
FEND: Far End
Only applicable to conditions supporting location. If no value is
specified, ALL is assumed.
[dirn] Direction of the condition. Valid value is RCV (Receive). ALL is not
supported.
Table 10-9. RTRV-ATTR-ADSL Command Parameters (2 of 2)
RTRV-ATTR-ADSL:[tid]:aidall_adsl:[ctag]::[ntfcde],[cond_ads
l],[locn],[dirn];