Paradyne 4200 - Manual (Page 287)

14. System Commands
4200-A2-GB20-00 August 2002 14-25
RTRV-NE-ALL
The RTRV-NE-ALL command retrieves common configuration data associated
with the NE.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response will be sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* RTRV-NE-ALL:[tid]:[aid_com]:[ctag][:] */
aid_com::ne_nblk
;
Error Response:
sid yy-mm-dd hh:mm:ss
M c DENY
/* RTRV-NE-ALL:[tid]:[aid_com]:[ctag][:] */
aid:ERRCDE=errcde
/* error description */
;
Table 14-21. RTRV-NE-ALL Command Parameters
RTRV-NE-ALL:[tid]:[aid_com]:[ctag][:];
RESTRICTION: All parameters in this command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
[aid_com] Access Identifier for all common equipment. The value can be preceded
with AID=, but this is not required. The value is COM.
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.