Paradyne 4200 - Manual (Page 89)

3. ADSL Facility Commands
4200-A2-GB20-00 August 2002 3-53
RTRV-PROFILE-ADSLUPALM
The RTRV-PROFILE-ADSLUPALM command enables you to retrieve ADSL alarm
configuration parameters associated with the downstream direction (from ATU-C
to ATU-R) in an ADSL Profile. See
ENT-PROFILE-ADSLALM on page 3-26 for
information on how to create a new ADSL profile.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/*
RTRV-PROFILE-ADSLUPALM:[tid]:adsl_profile_id:[ctag]:[::,prof
ile_scope] */
adsl_profile_id:profile_scope:profile_name:adslprof_nblk
;
Error Response:
sid yy-mm-dd hh:mm:ss
M c DENY
/*
RTRV-PROFILE-ADSLUPALM:[tid]:adsl_profile_id:[ctag][::profil
e_ scope] */
errcde
;
Table 3-41. RTRV-PROFILE-ADSLUPALM Command Parameters
RTRV-PROFILE-ADSLUPALM:[tid]:adsl_profile_id:[ctag][;;,prof
ile_scope];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] Identification of the target NE. TID is optional and has a default value of
null. The NE's SID code is the only other valid value.
adsl_profile_id Numeric identifier of a profile (1
−
30).
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
profile_scope The scope of a profile. The valid value is LOCAL (local to this stack
only). If no parameter is specified, this value is ignored (all values are
reported).