Paradyne 4200 - Manual (Page 155)

7. Equipment Commands
4200-A2-GB20-00 August 2002 7-9
RTRV-INV-EQPT
The RTRV-INV-EQPT command retrieves inventory data associated with a unit of
equipment.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* RTRV-INV-EQPT:[tid]:aid_eqpt:[ctag] */
aid_eqpt:cur_eqpt,manuf,partno,[rev],[serno],clei
;
Table 7-7. RTRV-INV-EQPT Command Parameters
RTRV-INV-EQPT:[tid]:aid_eqps:[ctag];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_eqpts Access identifier of an equipment unit. The value can be preceded with
AID=, but this is not required. Enter in one of the following formats,
replacing lower-case parameters with the values given:
NT: All Network Termination units
NTA Network Termination unit A
LT-rack-shelf-slot: All LT units in a shelf-slot
rack: Rack number (1)
shelf: Shelf number (1)
slot: LT slot number (1)
ATUR-rack-shelf-slot-circuit: ADSL endpoint attached to
LT-rack-shelf-circuit
LTA-rack-shelf-slot: Line Termination unit A (on main card)
LPCO-rack-shelf-slot: Low-Pass Filter-Central Office (in expansion slot)
SHELF-rack-shelf: General shelf and chassis-level information
Grouping is allowed. ALL may be used.
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.