Paradyne 4200 - Manual (Page 277)

14. System Commands
4200-A2-GB20-00 August 2002 14-15
RTRV-HDR
The RTRV-HDR command retrieves the NE header information.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response will be sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* RTRV-HDR:[tid]::[ctag] */
;
Error Response:
sid yy-mm-dd hh:mm:ss
M c DENY
/* RTRV-HDR:[tid]::[ctag] */
errcde
;
Table 14-14. RTRV-HDR Command Parameters
RTRV-HDR:[tid]::[ctag];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] The identification of the target NE. TID is optional and has a factory
default value of null. The NE's SID code is the only other valid value.
[ctag] The correlation tag that correlates an input command with its associated
output response(s). It is assigned by the originator of the command. The
value is limited to six characters, which may be an identifier or a decimal
numeral. It is optional with a default of 0.