Paradyne 4200 - Manual (Page 112)

5. ATM Commands
5-2 August 2002 4200-A2-GB20-00
DLT-PROFILE-TRAFDSC
The DLT-PROFILE-TRAFDSC command deletes a selected ATM Traffic Descriptor
profile that is not in use.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* DLT-PROFILE-TRAFDSC:[tid]:trafdsc:[ctag][:] */
;
Error Response:
sid yy-mm-dd hh:mm:ss
M c DENY
/* DLT-PROFILE-TRAFDSC:[tid]:trafdsc:[ctag][:] */
aid:ERRCDE=errcde
/* error description */
;
Table 5-1. DLT-PROFILE-TRAFDSC Command Parameters
DLT-PROFILE-TRAFDSC:[tid]:trafdsc_profile_id:[ctag][:];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
trafdsc_profile_id Numeric identifier of a profile (1
−
250). Grouping and ranging are
allowed.
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.