Paradyne 4200 - Manual (Page 107)

4. DS1 Facility Commands
4200-A2-GB20-00 August 2002 4-15
RTRV-T1
The RTRV-T1 command retrieves the configuration data associated with a DS-1
facility.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Table 4-12. RTRV-T1 Command Parameters
RTRV-T1:[tid]:aid_ds1:[ctag]::::[pstf],[sstf];
Restrictions: All parameters in this command are position-defined.
[tid] Identification of the target NE. They default value is null. The NE SID
code is the only other valid value.
aid_ds1 Access Identifier for the DS1 facility. The value can be preceded with
AID=, but this is not required. Grouping and ranging are allowed. Enter
in the following format, replacing lower-case parameters with the values
given:
NTT1-circuit
– circuit: DS1 circuit on the NT (1)
[ctag] Correlation tag (1...6 characters) that links an input command with
associated output responses. The default is 0.
[pstf] Primary state filter. Valid values are:
IS: Matches IS-NR
OOS: Out of service. Matches OOS-MA (out of service, management),
OOS-AU (out of service, autonomous), OOS-AUMA (out of service,
autonomous and management)
AU: Autonomous. Matches OOS-AU, OOS-AUMA
MA: Management. Matches OOS-MA, OOS-AUMA
If no value is specified, this filter is ignored.
[sstf] Secondary state filter. The value is:
LPBK: Retrieve looped-back entities only
If no value is specified, this filter is ignored.