Paradyne 4200 - Manual (Page 129)

5. ATM Commands
4200-A2-GB20-00 August 2002 5-19
RTRV-PROFILE-TRAFDSC
The RTRV-PROFILE-TRAFDSC command retrieves configuration parameters of
an ATM traffic descriptor file.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/*
RTRV-PROFILE-TRAFDSC:[tid]:trafdsc:[ctag]::,[profile_scope]
*/
trafdsc:profile_name:profile_scope:trafdscr_type:trafdscr_
nblk
;
Error Response:
sid yy-mm-dd hh:mm:ss
M c DENY
/*
RTRV-PROFILE-TRAFDSC:[tid]:trafdsc:[ctag]::,[profile_scope]
*/
errcde
;
Table 5-15. RTRV-PROFILE-TRAFSDSC Command Parameters
RTRV-PROFILE-TRAFDSC:[tid]:trafdsc_profile_id:[ctag]::,[pro
file_scope];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
trafdsc_profile_id Numeric Identifier for a traffic descriptor profile (1
−
250). Grouping and
ranging are allowed and ALL may be used.
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
[profile_scope] Scope of the profile. The valid value is LOCAL (local to this unit only).
If no value is specified, this parameter is ignored (all values are
specified).