Paradyne 4200 - Manual (Page 201)

10. Fault Commands
4200-A2-GB20-00 August 2002 10-9
RTRV-ALM-EQPT
The RTRV-ALM-EQPT command retrieves current alarms for specified equipment.
Table 10-5. RTRV-ALM-EQPT Command Parameters
RTRV-ALM-EQPT:[tid]:aid_eqpts:[ctag]::[ntfcde],,[srveff];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] The identification of the target NE. TID is optional and has a default
value of null. The NE's SID code is the only other valid value.
aid_eqpts Access identifier for the equipment. Each AID format can be preceded
with AID=, but this is not required. Enter in the following format,
replacing lower-case parameters with the values given:
LT-rack-shelf-slot: All LT units
LTA-rack-shelf-slot: LTA units
SHELF-rack-shelf: shelf
rack: Rack Number (1)
shelf: Shelf Number (1)
slot: LT Slot Number (1)
Grouping is allowed. ALL may be used.
[ctag] The correlation tag that links an input command with its associated
output responses. It is assigned by the originator of the command. The
value is limited to six characters, which may be an identifier or a decimal
numeral. It is optional with a default of 0.
[ntfncde] Notification code. Valid values are:
CR: Critical alarm
MJ: Major alarm
MN: Minor alarm
Grouping is allowed. If no value is specified, ALL is assumed.
[serveff] Service effect. Valid values are:
SA: Service affecting
NSA: Not service affecting
Grouping is allowed. If no value is specified, ALL is assumed.