Paradyne 4200 - Manual (Page 228)

10. Fault Commands
10-36 August 2002 4200-A2-GB20-00
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response will be sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* RTRV-COND-EQPT:[tid]:aid_eqpt:[ctag]::[cond_eqpt] */
"aid_eqpt,[aid_type]:[ntfncde],cond_eqpt,serveff,,,,,,{cond_
descr}"
;
Error Response:
sid yy-mm-dd hh:mm:ss
M c DENY
/* RTRV-COND-EQPT:[tid]:aid_eqpt:[ctag]::[cond_eqpt] */
errcde
;
Table 10-22. RTRV-COND-EQPT Response Parameters (1 of 2)
Parameter Explanation
tid Target NE identification
yy-mm-dd Year, month, and day
hh:mm:ss Hour, minute, and second
M Message generated in response to an input command
c If provided, ctag; otherwise 0
COMPLD Completed
DENY Input command is denied
/* */ Enclosed are human readable comments – unspecified format
errcde Error code (see Appendix A, Error Codes )
aid_eqpt As described for command parameters (see Table 10-21,
RTRV-COND-EQPT Command Parameters ), except ALL is not used.
aid_type The type of Access Identifier. The value is EQPT.
[ntfncde] Notification code. Valid values are:
CR: Critical alarm
MJ: Major alarm
MN: Minor alarm
NA: Not alarmed (reported via REPORT EVENT)