Paradyne 4200 User Manual
Page 225
10. Fault Commands
4200-A2-GB20-00
August 2002
10-33
DENY
Input command is denied
/* */
Enclosed are human readable comments – unspecified format
errcde Error
code
aid
Access Identifier of the entity reporting the alarm. Valid values are:
SHELF-rack-shelf
NTA
LTA-rack-shelf-slot
ADSL-rack-shelf-slot-circuit
NTT1-circuit
aid_type
The type of Access Identifier. Valid values are ADSL, EQPT, and T1.
[ntfncde]
Notification code. Values are:
CR: Critical alarm
MJ: Major alarm
MN: Minor alarm
NA: Not alarmed (reported via REPORT EVENT)
NR: Not reported (information is stored in the NE). This value is
supported for the ADSL condition NOPEER (no peer ATU present).
cond
As described for command parameters (see
RTRV-COND-ALL Command Parameters
), except that ALL is not used.
[serveff]
Service effect. Values are:
SA: Service affecting
NSA: Not service affecting
[locn]
Location of the condition. Valid values are:
NEND: Near End
FEND: Far End
[dirn]
Signal direction. Valid values are:
RCV: Receive
TRMT: Transmit
Table 10-20. RTRV-COND-ALL Response Parameters (2 of 2)
Parameter Explanation