Paradyne 4200 - Manual (Page 138)

6. Cross Connect Commands
6-4 August 2002 4200-A2-GB20-00
ED-CRS-VC
The ED-CRS-VC command edits the configuration of a VC-level cross-connection
between the NT and an LT.
Table 6-3. ED-CRS-VC Command Parameters
ED-CRS-VC:[tid]:nt_vcl,lt_vcl:[ctag]::::[pst];
RESTRICTIONS: The following restrictions apply to this command:
T All parameters in this command are position-defined.
T This command requires two AID parameter entries to uniquely identify an existing
cross-connection.
T The deletion of a cross-connection is conditional on its current operational state. All
endpoints must be edited OOS-MA-AS or the command will fail.
T A partial (PRTL) response is generated if all cross-connections cannot be deleted.
T The range of values for vpi and vci is determined by the number of VPI and VCI bits
allocated.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
nt_vcl Virtual Channel Identifier for the Virtual Channel Link on the NT
(network) side. Grouping and ranging are allowed. Enter in the following
format, replacing lower-case parameters with the values given:
NTVCL-vpi-vci
– vpi: Virtual Path Identifier
– vci: Virtual Channel Identifier for the Virtual Channel Link
lt_vcl Virtual Channel Identifier for the Virtual Channel Link on the LT (user)
side. Grouping and ranging are allowed.
Enter in the following format, replacing lower-case parameters with the
values given:
LTVCL-rack-shelf-slot-circuit-vpi-vci: LT circuit
– rack: Rack number (1)
– shelf: Shelf number (1)
– slot: LT slot number (1)
– circuit: ADSL circuit on the LT (1
−
4)
– vpi: Virtual Path Identifier (for LT vpi=0, for NT vpi=0
−
15)
– vci: Virtual Channel Identifier for the Virtual Channel Link (for LT
vpi=32
−
63, for NT vpi=32
−
1023)
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
[pst] Desired Primary State. Valid values are:
IS: In-Service
OOS: Out-Of-Service (OOS-MA is implied)
If not specified, the value of this parameter remains unchanged.