Paradyne 4200 - Manual (Page 152)

7. Equipment Commands
7-6 August 2002 4200-A2-GB20-00
RTRV-EQPT
The RTRV-EQPT command retrieves configuration data associated with a unit of
equipment.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* RTRV-EQPT:[tid]:aid_eqpts:[ctag] */
aid_eqpts:[eqpt_type],[cur_eqpt]:[eqpt_nblk]:state,[sst]
;
Table 7-5. RTRV-EQPT Command Parameters
RTRV-EQPT:[tid]:aid_eqpts:[ctag][:];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_eqpts Access identifier of an equipment unit. The value can be preceded with
AID=, but this is not required. Enter in one of the following formats,
replacing lower-case parameters with the values given:
– NT: All Network Termination units
– NTA Network Termination unit A
– LT-rack-shelf-slot: All LT units in a rack-shelf-slot
– rack: Rack number (1)
– shelf: Shelf number (1)
– slot: LT slot number (1)
– LTA-rack-shelf-slot: Line Termination unit A (on main card)
– LPCO-rack-shelf-slot: Low-Pass Filter-Central Office (in
expansion slot
Grouping is allowed. ALL may be used.
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.