Paradyne 4200 - Manual (Page 183)

9. Performance Commands
4200-A2-GB20-00 August 2002 9-3
Table 9-2. REPT-OPSTAT-ADSLCOM Response Parameters
Parameter Explanation
tid Target NE identification
yy-mm-dd Year, month, and day
hh:mm:ss Hour, minute, and second
M Message generated in response to an input command
c If provided, ctag; otherwise 0
COMPLD Completed
DENY Input command is denied
/* */ Enclosed are human readable comments – unspecified format
errcde Error code (see Appendix A, Error Codes )
aid_adsl As described for command parameters (see Table 9-1,
REPT-OPSTAT-ADSLCOM Command Parameters ).
op_adsl ADSL operational parameter. Parameters are:
STATUSNE: Current status of near-end modem (ATU-C). Values are:
– NORMAL: no failure condition
– LOF: Loss Of Framing
– LOS: Loss Of Signal
– LORATE: Line rate is below planned rate (Loss of Signal Quality)
– LOL: Loss Of Link
– LOCD: Loss Of Cell Delineation
– INITF: modem initialization failure
– NOPEER: No peer ATU present
STATUSFE: Current status of far-end modem (ATU-R). Values are:
– NORMAL (no failure condition)
– LOF (loss of framing) LOS (loss of signal)
– LORATE: Line rate is below planned rate (Loss of Signal Quality)
– LPR (loss of power to modem)
LASTCHNGDATE: Date of last change in the operational state of the
modem. Values are mm-dd (month and day), where mm= 00
−
12 and
dd = 00
−
31.
LASTCHNGTIME: Time of last change in the operational state of the
modem. Values are hh-mm (hour and minute), where hh = 00
−
23 and
mm = 00
−
59.
value Value of parameter specified by op_adsl