Paradyne 4200 - Manual (Page 182)

9. Performance Commands
9-2 August 2002 4200-A2-GB20-00
REPT-OPSTAT-ADSLCOM
The REPT-OPSTAT-ADSLCOM command reports current operational parameters
of ADSL lines that are common for both upstream and downstream directions.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* REPT-OPSTAT-ADSLCOM:[tid]:aid_adsl:[ctag][:] */
"aid_adsl:op_adslcom,value"
;
Error Response:
sid yy-mm-dd hh:mm:ss
M c DENY
/* REPT-OPSTAT-ADSLCOM:[tid]:aid_adsl:[ctag][:] */
aid:ERRCDE=errcde
;
Table 9-1. REPT-OPSTAT-ADSLCOM Command Parameters
REPT-OPSTAT-ADSLCOM:[tid]:aid_adsl:[ctag][:];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_adsl Access identifier for ADSL lines. The value can be preceded with AID=,
but this is not required. Grouping and ranging are allowed. Enter in the
following format, replacing lower-case parameters with the values
given:
ADSL-rack-shelf-slot-circuit rack:
– rack: Rack number (1)
– shelf: Shelf number (1)
– slot: LT slot number (1)
– circuit: ADSL circuit on the LT (1
−
24)
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.