Honeywell INTELLIKNIGHT 5820XL - Manual (Page 99)

SD and SK SLC Device Installation
151209 5-9
5.7 Wiring SD Detectors
The information in this section applies to the following SD models: This section
describes how to install SD heat and smoke detectors. All detectors ship with
installation instructions. Refer to each detectors' installation instructions for more
detailed information.
To wire SD detectors:
1. Wire device bases as shown in Figure 5-6.
2. Set the address for each device as described in Section 5.8.
3. If you are connecting to the main panel, do not connect any devices to terminals
35 and 36. If you are connecting to the 5815XL, do not connect any devices to
“SLC IN”.
Figure 5-6 Heat or Smoke Detector Connection to the FACP