Honeywell INTELLIKNIGHT 5820XL - Manual (Page 105)

Programming Overview
151209 6-3
6.1.3 Running JumpStart
Run JumpStart immediately after you have addressed and connected all input
devices (detectors, pull stations, and so on) and output devices (notification
appliances, relays, and so on).
Note: If you need to install a few devices after you have run JumpStart, you can install them manually.
Follow instructions in Section 8 for configuration.
To run JumpStart, follow these steps.
1. Press to view Main Menu.
2. Select for Program Menu.
3. From the next menu, select for JumpStart.
4. The message “WARNING Will DELETE all system options” displays on the LCD.
Select Yes to continue. A series of messages displays for the next several sec-
onds. JumpStart scans the SLC loops for devices. This can take several minutes,
depending on the number of devices attached.
5. When the message, “SLC FAMILY” flashes. Press to accept SD if installing,
or press to display SK and press to accept SK.
6. When the message “Configuring System Done” displays, press any key to con-
tinue.
7. Select one of the following options from the menu that displays.
- Review System Press if you need to review the JumpStart configuration.
- Repeat JumpStart Press if you need to rerun JumpStart for any reason.