Honeywell INTELLIKNIGHT 5820XL - Manual (Page 187)

System Operation
151209 8-13
Alarm
A smoke
detector
goes into
alarm or a
pull station
is activated.
CO Detector
goes into
alarm.
If more then
3 categories
are active at
a single
time, screen
will display
as shown.
The dialer seizes control of the phone line and
calls the central station.
The on-board annunciator sounds a loud,
steady beep (any notification devices attached
to the system will also sound).
GENERAL ALARM LED flashes.
The LCD displays a screen similar to this
one.
Press the down arrow to view the alarm. A
screen similar to this one displays.
Press and enter an access code (or
activate the key) to silence the annunciator (and
any notification devices attached to the
system).
When the alarm condition clears, press
and enter a code (or activate the key)
to restore the panel to normal.
After sitting idle, events will display in a screen
similar to this.
Note: Alarm and Prealarm are com-
bined into single alarm count.
Table 8-1: Operation Mode Behavior
Operation
Mode
Occurs
When
System Behavior In This Mode You Can
SILENCE
RESET