Honeywell INTELLIKNIGHT 5820XL - Manual (Page 141)

Programming
151209 7-15
7.5 Group
An output group is made up of output points that have been programmed to respond
in the same way. Output groups simplify programming because you have to program
the output characteristics that are common to all of the group points once, instead of
programming each individual point. Once you have defined the characteristics of
output groups, you can assign each point to the appropriate group. All valid output
points are assigned to only one output group. Unused points are not assigned to any
output group. Up to 250 output groups can be defined.
7.5.1 Edit Group
In the edit group option you can program the name of an output group (Section
7.5.1.1) and change the properties (Section 7.5.1.2) of that group.
To edit a group, follow these steps:
1. Enter the installer code.
2. Press
or
to display the main menu.
3. Select for Program Menu.
4. Press to enter group menu.
5. Press to edit group.
6. Enter the number of the group you wish to edit, then press .
7.5.1.1 Edit Group Name
7. To edit the group name, press .
A screen similar to the one shown in Figure 7-7 displays.
Figure 7-7 Editing Group Name Example
8. Select the characters for the zone name by pressing the or arrow until the
desired character is shown then press .
OR
ENTER
ACK
ENTER
ACK