Honeywell INTELLIKNIGHT 5820XL - Manual (Page 97)

SD and SK SLC Device Installation
151209 5-7
5.5 Wiring SK SLC Detectors
This section describes how to install SK heat and smoke detectors. All detectors ship
with installation instructions. Refer to the detector’s installation instructions for more
detailed information.
This information applies to the following SK models:
• SK-Photo Photoelectric Smoke Detector
• SK-Photo-T Photoelectric Smoke Detector with Thermal
• SK-Acclimate Photoelectric Smoke Detector with Thermal
• SK-Heat Fixed Temperature Detector
• SK-Heat-T High Temperature Thermal Detector
• SK-Heat-ROR Rate-of-Rise Thermal Detector
• SK-Ion Ionization Smoke Detector
• SK-FIRE-CO CO Detector
Wiring SK detectors:
1. Wire device bases as shown in Figure 5-4.
2. Set the address for each device as described in Section 5.6.
Figure 5-4 Heat and Smoke Detector Connection to the Panel.
Caution: Do not loop wire under Terminal 1 or 2.
Break wire run to provide supervision of connections.
Class A wiring:
Class B wiring:
...............