Honeywell INTELLIKNIGHT 5820XL - Manual (Page 190)

IntelliKnight 5820XL Installation Manual
8-16 151209
Prealarm A single
detector
trips in a 2-
Count zone.
(2-Count
means two
detectors
must trip
before an
alarm is
reported.) Touchpad PZT beeps.
The LCD displays a screen similar to this one.
Press (down arrow) to view the prealarm. A
screen similar to this one displays.
All system operations are available in this
mode.
After sitting idle, events will be display on
screen similar to this:
Note: Alarm and Prealarm are com-
bined into a single alarm count.
Reset The
button is
pressed
followed by
a valid code
or rotation of
the key.
All LEDs are on briefly then the LCD displays
“ALARM RESET IN PROGRESS”. If the reset
process completes normally, the date and time
normal mode screen displays. Menus are not available during the reset
process.
Silenced An alarm or
trouble
condition
has been
silenced but
still exists.
To silence
alarms and
troubles,
press
followed by
the Installer
or User
Code or
rotate the
key.
SYSTEM SILENCE LED is on. SYSTEM
TROUBLE, SUPERVISORY or GENERAL
ALARM LED (depending on condition) is on.
The annunciator (and any notification devices
attached to the system) will be silenced.
Press (down arrow) to view the location of
the alarm or trouble. When the condition no
longer exists, the SYSTEM SILENCED and
SYSTEM TROUBLE LED, SUPERVISORY or
GENERAL ALARM LEDs turn off.
Table 8-1: Operation Mode Behavior
Operation
Mode
Occurs
When
System Behavior In This Mode You Can
RESET
SILENCE